Welcome, Guest
Username: Password: Remember me

TOPIC: Replacing speaker on ASP installed saber

Replacing speaker on ASP installed saber 4 weeks 22 hours ago #88385

  • Danielbs80
  • Danielbs80's Avatar
  • Offline
  • Elite Member
  • Posts: 290
  • Thank you received: 29
So i have an asp saber i got recently in which i had the champion install service done so it came all assembled but i reciently discovered the speaker they used is not the same higjh bass speaker they sell although ot looks like it so i havent been getting the rich deep bass sounds i like as with my NBv4 build that has rhe high bass speaker from saberforge so i ordered what i hope to be a good speaker from tcss and plan om replacing the stock speaker. Although i was able it shake the electonics out enough to access the speaker i would lole to pull it out as far as ot will gp but i dont know how much excess wire is there. Is it safe to assume that of it wont come futher out with more shaking then that's the wire holding it back so pullong it will prolly pull the wire out of its solder joint or is it just hard to slide due to the velcro and needs to be pulled?

The administrator has disabled public write access.

Replacing speaker on ASP installed saber 4 weeks 13 hours ago #88393

  • Jas-Ot
  • Jas-Ot's Avatar
  • Offline
  • Platinum Member
  • Posts: 1271
  • Thank you received: 511
Its not going to come out any further.

You will need to desolder it from there.
www.etsy.com/shop/thekybershop

www.facebook.com/jasotsabers
The administrator has disabled public write access.

Replacing speaker on ASP installed saber 4 weeks 8 hours ago #88403

  • Danielbs80
  • Danielbs80's Avatar
  • Offline
  • Elite Member
  • Posts: 290
  • Thank you received: 29
I may want to take out the electronics at some point and install the plug and play Hero Electronics some point down the road so if I want to do that I would need to completely disassembled the sabre does anyone know a good way to get the glue to unlock the threads?
The administrator has disabled public write access.

Replacing speaker on ASP installed saber 4 weeks 7 hours ago #88408

  • DarthRevan17
  • DarthRevan17's Avatar
  • Offline
  • Premium Member
  • Posts: 82
  • Thank you received: 40
Just take a heat gun to it and it should loosen up the glue
You can not hold me to the Jedi’s rules....
The administrator has disabled public write access.

Member Login

Latest Posts

    • Shipped! Saberforge Legac... (1 Posts)
    • Today I got an email from Saberforge that my Legacy Monarch has shipped! After eleven months of lead...
    • Saber Selfies (307 Posts)
    • Really channeling the dark side with this one! [attachment] Like I said on my DST post,...
    • Pink Dual Tone Talon (12 Posts)
    • Quote: So how did you get the silver emitter prongs? Did they charge you for it? No extra charge. I...

More Topics »

Forum Statistics

  • Total Users: 6835
  • Latest Member: ValkyrieGondul
  • Total Posts: 69.1k
  • Total Topics: 5825
  • Total Sections: 24
  • Total Categories: 145
  • Today Open: 2
  • Yesterday Open: 4
  • Today Answer: 8
  • Yesterday Answer: 31