|
Welcome, Guest
|
TOPIC: Saber help
Saber help 1 year 2 months ago #8940
|
So my Champion Guardian arrived today, and I was wondering if anyone could tell me how to get at the LED module on it to see if the quick connects I requested were installed?
The module seems pretty tight in there so I don't want to mess around with it too much in case I Break it or something. |
|
Own:
- 12W Green Champion Guardian - Reborn DT |
Saber help 1 year 2 months ago #8941
|
If I'm correct, then there should be two little screws on the hilt. One blade retention-screw and one more below that. The lower one should be the one holding the LED module in place. Losen it and you should be able to shake the module out.
|
Saber help 1 year 2 months ago #8949
|
I'll give it a go, thank you!
|
|
Own:
- 12W Green Champion Guardian - Reborn DT |
Saber help 1 year 1 month ago #9001
|
The suggestion was spot on, just never seen the retention screw hole as it was covered by the shroud ha
Yeah once I got it out I had to be careful putting it back in because of the wires but I got it eventually and it's all good now  Have absolutely no idea how to seperate the quick connects though ha didn't want to just pull at them in case I pulled a wire out or something but for now it's fine, I'll cross that bridge when I get to it |
|
Own:
- 12W Green Champion Guardian - Reborn DT |