TOPIC: lighted AV switch specs

lighted AV switch specs 10 months 1 week ago #72882

gavinvs Offline New Member Posts: 2	I have 2 Saberforge lighted AV switches (red segmented and purple segmented). I can't find the specs anywhere online - does anyone know the forward voltage of these and their maximum current? Thanks!
	The administrator has disabled public write access.

lighted AV switch specs 10 months 1 week ago #72922

Jas-Ot Offline Platinum Member Posts: 1046 Thank you received: 322	Red is 2v and 20mah Purple is 3v and 20mah Dyna ohm works perfectly on both.
	The administrator has disabled public write access.

lighted AV switch specs 10 months 1 week ago #72971

gavinvs Offline New Member Posts: 2	I don't think this is true. Using a dynaohm and a battery pack providing 3-12v, the switch is only drawing a max of about 5mA. Its also significantly dimmer at 3/4.5 V than at 6-12V. I know the TCSS switches are 2/3V and 20mA, I have some of those that using the same setup clearly show 20mA. But from the tests I've done it seems like the Saberforge ones have an internal resistor.
	The administrator has disabled public write access.

lighted AV switch specs 9 months 4 weeks ago #73288

Starganderfish
Offline
New Member
Posts: 5
Thank you received: 1

I'd love to know specs and resistor requirements for these also.
I have Purple and Amber segmented's I want to use in a small build. Not using a SF board (Plector Pico Crumble) so would be removing the plug and play connector and soldering directly to the board.
Be nice to know what resistor is needed.

Be nice if SF privided a few more details of their products - sizes, current/voltage, any of that stuff...

The administrator has disabled public write access.

lighted AV switch specs 9 months 3 weeks ago #73346

Jas-Ot Offline Platinum Member Posts: 1046 Thank you received: 322	Run a dyna ohm on them and you will be fine.
	The administrator has disabled public write access.

lighted AV switch specs 9 months 3 weeks ago #73347

Vechaljian Offline Platinum Member Posts: 348 Thank you received: 199	As Jas-Ot says run a dyna ohm, and your set
	The administrator has disabled public write access.

Forum

Saber DIY

Saber Electronics DIY

lighted AV switch specs