Saber Forge :: Topic: Wiring help (resistor) (2/2)

Welcome, Guest

Forum

Saber DIY

Saber Electronics DIY

Wiring help (resistor)

TOPIC: Wiring help (resistor)

Darth Floyd wrote:

janus wrote:

Yeah if you have warrior tier, switch hole sizes are completely same as 12mm lit switch.
Just put and glue it.

Cool thanks! And you don't need a resistor? I assume without a kill key the light ring stays iluminated as long as the batteries are in?

"janus wrote:

and if you will use 3.7V Li-ion 186500(SF default battery), 170ohm resistor is needed for lit switch.

The administrator has disabled public write access.

janus OFFLINE Elite Member Posts: 174 Like received: 23	Yes, you need 170 ohm resistor. And kill key equipment is recommended because of the reason you mentioned. There is a wiring way that lit switch go off during deep sleap, but it didn't work well in my case. Warrior tier has two holes, you may easily equip recharge port too, I guess.
	Own: Descent Hero RGBA Luxeon converted Hasbro Darth Maul FX Ultrasabers Guardian Juggernaut warrior The administrator has disabled public write access.

Forum

Saber DIY

Saber Electronics DIY

Wiring help (resistor)