So, I started working on a lightsaber pen. I started with Ahsoka's saber just because it was the last one I was working on.
Here are the results of version .2 which is the first version to hold a pen, and is a little skinner than my .1 version.
The cap(pummel) doesn't stay on unfortunately, I didn't make it tight enough. I think I will try and make it a little screw on piece.
My wife is always suggesting I open an Etsy store for some of my 3d printed things, and if I can get these pens down and have more designs to work, and get them to print in less than 5.5 hours.... I might actually do it. I will keep you guys updated on how my attempts go at fixing my cap issue.
Any suggestions for a saber hilt you would like to see as a pen?