|
Welcome, Guest
|
|
TOPIC: Ultra Sabers Graflex Revamp
Ultra Sabers Graflex Revamp 1 year 7 months ago #63770
|
Classy
|
Ultra Sabers Graflex Revamp 1 year 7 months ago #63787
|
Thanks guys.
Also, a couple other notes: It's (intentionally) hard to see, especially with the weathering, but there are two new slits cut above and below the Kobold clip to help more sound vent out the pommel. There's foam padding inside the hilt to prevent the resistors from rattling/clanking against the hilt. However, they still vibrate in tune with the audio, making for some really nice haptic feedback to ignition and swings when the hilt's held by the front half. I forget if this was mentioned, but the red Graflex button is a blade-retention thumbscrew. Tool-free blade swapping. Also, I'll get a video demo later on, but Obsidian V4's been reconfigured for 6 soundfonts. 1) Episode 3 2) Episode 4 3) Episode 5 Graflex 4) Episode 7 Graflex 5) Obisidian Default 6) Silent |
Ultra Sabers Graflex Revamp 1 year 4 months ago #69001
|
Dug this one back up to tinker with between projects.
Replaced the activation box and shroud with a BS Luke clamp. Tactile switch hidden underneath a Graflex 2.0 circuit board. 
Planning on cutting the hilt in half so I can rotate the grips into TFA position, along with replacing these low-profile grips with a more accurate set. |
Ultra Sabers Graflex Revamp 3 months 2 weeks ago #82841
|
Where did you get the clamp and pommel? This is beautiful and i am wanting to upgrade my US Graflex as well.
|
Ultra Sabers Graflex Revamp 3 months 2 weeks ago #82848
|
Clamp was taken off of a Black Series ANH Luke hilt. Pommel's a TCSS flat pommel with a custom-machined insert,, but no reason you can't get their solid pommel insert and make the holes yourself.
|
|
The following user(s) said Thank You: Rdprieto22
|
|