Saber Forge :: Topic: Upgrading an Initiate Consular (1/1)

Welcome, Guest

Forum

Reviews

Apprentice Sabers

Consular

Upgrading an Initiate Consular

TOPIC: Upgrading an Initiate Consular

Upgrading an Initiate Consular 4 months 2 weeks ago #14459

Guff
OFFLINE
New Member
Posts: 12

Hi folks,

During the memorial day I ordered a Gladius warrior edition, a Consular warrior and an initiate Consular as well (to tip me over the $500 mark for extra rewards). I had the intention of swapping out the eletronics from the Gladius to use on the initiate consular. I've since read that because the apprentice sabers are a solid piece, this could be tricky to do.

Have I made a horrible mistake, or is it possible to upgrade this saber?

Cheers!

The administrator has disabled public write access.

Upgrading an Initiate Consular 4 months 2 weeks ago #14463

Knytiri NOW ONLINE Administrator "Luminous beings are we, not this crude matter." Posts: 1563 Like received: 276	Of course it is possible, it's just tricky and harder to work in the apprentice sabers because they're smaller and one single piece than it is in the elite sabers.
	The administrator has disabled public write access.

Upgrading an Initiate Consular 4 months 2 weeks ago #14467

Guff OFFLINE New Member Posts: 12	How tricky we talking I do have small fingers
	The administrator has disabled public write access.

Upgrading an Initiate Consular 4 months 2 weeks ago #14477

Knytiri NOW ONLINE Administrator "Luminous beings are we, not this crude matter." Posts: 1563 Like received: 276	Do you have experience doing installs before?
	The administrator has disabled public write access.

Upgrading an Initiate Consular 4 months 2 weeks ago #14479

Guff OFFLINE New Member Posts: 12	Nope Done a bit of soldering before though. Will that be required even with the quick connects?
	The administrator has disabled public write access.

Upgrading an Initiate Consular 4 months 2 weeks ago #14483

Knytiri NOW ONLINE Administrator "Luminous beings are we, not this crude matter." Posts: 1563 Like received: 276	Yeah. In order to get the electronics out of the first hilt you'll probably end up disconnecting a few wires from the switch, which will need to be resoldered back on. I'm not overly skilled in that department, just have general knowledge of what happens and goes on, but there are others who do, lol. I would say that you're probably in for at least a little bit of an adventure!
	The administrator has disabled public write access.

Upgrading an Initiate Consular 4 months 2 weeks ago #14487

Lightsideuser#1 OFFLINE New Member Posts: 13	I'm not sure but maybe you could send it back to saberforge and they can do the install. the only problem would be that it would cost money. but then you would have three warrior sabers!
	The administrator has disabled public write access.