I'm thinking of getting a Disciple hilt with the $55 tier 2 warrior extension.

Ok thank you,

the following has been taken from the FAQ page..

Warrior - Basic stunt saber. Comes with your choice of 6W or 12W LED. 6W Warrior runs on AAA batteries, that you will need to supply. 12W Warrior comes with the 18650 rechargeable battery and a charger for said battery. You will need to remove the battery through the bottom of the hilt to recharge it. Also comes with a blade, your choice of 26, 32, or 37in Infinity Edge v4 blade, covertech wheel is installed on the saber (covertech belt clip does come as a separate piece), and a blade plug. Apprentice and Elite sabers have two different models of blade plugs, as the Elite model blade plug cannot fit in an Apprentice Acolyte or Disciple, due to the lip on the plug and the slanted emitter on the saber.

As you can see you do get a blade plug and blade.

I hope this helps

For Tyeth

Thanks for the thorough and clear response. I just have 2 more questions.

1. What is an LED quick connect?

2. And where can I see what the Phoenix and Imperial saber stands look like?

Thanks.

LED Quick Connect is a connector placed on the wires between the power source, and the LED unit so that you can disconnect it, and put in an alternate LED unit (also with Quick Connects), without the need for soldering.

As for the stands, Saberforge's Etsy store should have them.

And for the hilt stands?

The Saberforge Etsy store should have images of them, and there are likely some around the forum also, but those could be a little harder to locate.

Hi you're welcome as you might have guessed I have a Disciple so glad to help! (You can see it in the review section if you like)

The LED Quick Connects are special connectors to enable you to remove the blade then remove the LED module from the saber and "Unclip" the LED module then "Clip" a different coloured LED module in place. This changes the colour of your saber.
The Quick Connects look like this



The saber stands are

The Phoenix









The Imperial Stand









Please note the sabers do not come with the stands!

Hope this helps and I look forward to seeing your Disciple in the future,

For Tyeth

Oh wow that's pretty cool, so I can purchase different LEDs and just replace them with my standard one? Sounds pretty neat.

Hi again,

Yes, but you have to select Quick Connects when you make your order (costs a little more but gives you the option to change colours fairly quickly!) Any LED modules you purchase later also need the connectors on so remember to specify that when ordering them.

Glad I could help and I look forward to seeing more of your posts (and maybe some pics of your Disciple!)

For Tyeth
MTFBWY