TOPIC: Need to remove av switches and recharge port

Need to remove av switches and recharge port 3 months 3 weeks ago #40379

Darthgenocidius Offline New Member Posts: 3	Working on a Hero tier descent, I'm upgrading to a RGB setup from a 6w/6w/12w set up. How do I go about taking this thing apart? Wiring is not long enough to get the board and battery out with out removing the switches and recharge port.
	The administrator has disabled public write access.

Threaded Indented

Forum

Saber DIY

Saber Hilt DIY

Need to remove av switches and recharge port

Powered by Kunena Forum

- Wiring in Parallel (4 Posts)
- I honestly wouldn't mind. I've had a lot of fun learning about the stuff so far, but I don't know...
- Request For ASP To Ship A... (22 Posts)
- ^ Agree entirely. Welcome to the Forum too! I think $15 or $20 would more than cover the cost of...
- Wiring in Parallel (4 Posts)
- He doesn't because the two amber dies need resistors but not the white one. Plus I've been told it's...
- Wiring in Parallel (4 Posts)
- It *can* be done by bridging connections, but it's not really needed. Parallel, as far as LEDs go,...
- Any one know if Saberforg... (16 Posts)
- Nice, that's not all that bad to be honest. Your saber can finally join the others with their 12Ws...